PasturePro Posts

The Pasture Pro Post is the ideal line post in most fencing scenarios. This wood/poly blended post has excellent flexibility, visibility, and is easy to install. In ideal soil conditions only a regular t-post hand driver is necessary. You may also use a gas or pneumatic driver. In rocky and/or hard ground conditions, a pilot driver or even hammer drill may be necessary. To install the wire using the cotter pin method, drill a 7/32" hole where you would like the wire to sit but only after the post has been set. Do not predrill! The grip these posts have to soil once installed is very strong and you will not be able to twist to realign a misplaced hole.

Sort by

Show
24
36
48

View as

$143.75

(Sold Out - ETA Unknown)25 Pack of PasturePro Line Posts 1-1/8" x 4'

The 1-1/8" x 4' PasturePro Composite Post is ideal for fences no taller than 32". This assumes the installer drilling the first hole 1" from the to...

View full details

$143.75

$156.25

(Sold Out - ETA Unknown)25 Pack of PasturePro Line Posts 1-1/8" x 4.5'

The 1-1/8" x 4.5' PasturePro Composite Post is a good post for permanent subdivision multi-wire fences. Post spacing is dependent on terrain and...

View full details

$156.25

$10.75

Cotter Pins 5.5" x 14 Gauge 100/pk

Cotter pins are the preferred method of connecting wires to Fiberglass, PasturePro & G2 Poly Posts. A 7/32 drill bit is recommended as it remov...

View full details

$10.75

from $99.00

Pilot Driver for PasturePro, G2, PVC, or Fiberglass Post Installation

PasturePro Post Pilot Driver really does help when you are in very hard or rocky soils. On the other hand, if you have good soft top soil you will ...

View full details

from $99.00